Type 2020 electronic
With the aid of the Wocafix Appliance 2020 electronic thin, true-to-size coatings of hard metal (tungsten carbide) can be applied to any types of steel. The thickness of the coating is adjustable between 2 and 40 my mm.
Nowadays very exacting demands are made on the toughness, hardness and surface wear resistance of tools, equipment and machine parts. Through the normal hardening method only toughness or hardness can definitely be achieved; in practice therefore, a middle course is selected.
In the search for a tough material with a more wear-resistant coating the following possibilities presented themselves:
1. Galvanic coating with hard coats
2. The plasma gun spraying method
3. Electro-erosive wocafix coating
The adhesive strength of the coatings in methods 1 and 2 is unsatisfactory in the case of heavy stresses since the coatings are likely to scale off. With the third method however, it is possible to apply tungsten carbide to a very wear-resistant surface on the heavily stressed points of a workpiece.
Micro-Section magnified 250 times
|coating up to 82 Rockwell|
|rehardened 75 Rockwell|
|base material (steel)unaltered|
Properties of the hard metal coating
The coating applied joins perfectly with the steel and adheres in such a way that it withstands any mechanical stress. No blows, bending, stretching or compressive strains will even partially remove the coating. This can be done only by grinding or special sand blasting; it can however, be relapped with diamond or silicon carbide. The steel beneath is not softened by the coating but increased in hardness in the upper zone. In the case of certain steel alloys the tungsten carbide coating penetrates the base material. The coating produces a hardness of up to 82 Rc (Rockwell), without the workpiece undergoing any change or distortion since the depositing process is practically cold. The coating is highly heat resistant and thanks to the high degree of temper the wear resistance is considerably increased.
The surface is smooth and shows no directional texture; good saturation will ensure a medium roughness of from 2 to 9 my.
Materials and their pretreatment
Suitable as material for coating with Wocafix is any soft, heat-treated or hardened steel as well as all types of steel including the highest alloyed ones. The surface must be clean and metallically pure. Scale and oxide coatings must be removed without fail. Ground, polished or brightly tooled parts must be degreased. If the Wocafix coating is applied to an unclean surface no satisfactory adhesive strength can be obtained and the coating will become irregular and show inclusions.
Method of operation
The Wocafix Appliance operates in accordance with the principle of electro-erosion. A tungsten carbide electrode is attached to the positive pole in a D. C. circuit with electric current and voltage regulation to which are connected condensers of varying capacities. The electrode is fitted in a vibrator gun. Through the vibrator oscillations are set up in the electrode and this is brought into contact with the workpiece to be treated. The workpiece is connected to the negative pole. Through the contact of the electrode with the workpiece a ionised field is produced which guarantees an oxide-free smelting of the tungsten carbide with the base material. With the help of the vibrator this field is continually built up, the constant to and fro movement of the electrode producing a compact Wocafix coating. The preselected thickness of the coating cannot be exceeded since when saturation is reached no further absorption of material takes place. The selected coating thickness is so exact that no subsequent treatment is required. In case of need the surface can be polished or relapped.
The Wocafix coating process with the appliance 2020 electronic is so simple that it can be carried out by anyone.